TSC TDP-245 PLUS DRIVER

Loading Label In Cutter Mode 3. Remove the front panel from the lower cover. Feed the label, printing side facing up, through the label guide and pass over the platen. Plastic pillar Copper pillar Squeeze two sides of platen assembly and take it out. Update History Modify section 3. Read more about the condition. Page 58 Interior Brush or vacuum As needed Note:

Uploader: Majas
Date Added: 12 August 2006
File Size: 44.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 8274
Price: Free* [*Free Regsitration Required]

Tsc tdp plus the liner paper through the label opening of peel off module, which is beneath the roller. Front View, Rear View 1. Tsc tdp plus 1 screw and open the memory card cover.

TSC TDP Plus Thermal Barcode Label Printer 4 X 6 POS | eBay

Pull the top cover open levers tsc tdp plus open the top cover. Table Of Contents 1. The only one exception is ribbon sensitivity, which will note be restored to default. Remove the front panel from the lower cover.

Download TSC TDP Driver

Fasten the copper pillar and plastic pillar. This is completely new driver release, based on new driver platform. Remove 6 screws on lower inner cover. This manual also for: Page 33 — install sd memory card Trp 34 Page 35 — peel-off installation option tsc tdp plus Page 36 Page 37 Page 38 — loading label for peel-off mode option Page 39 Page 40 — cutter module installation option Page 41 Page 42 — loading label in cutter mode Page 43 — internal ethernet interface installation SD Tsc tdp plus Revert the memory card cover.

Related Drivers  46M0907 TREIBER

Page 58 Interior Brush or vacuum As needed Note: Feed the label, printing side facing up, through the label guide and pass over the platen. Loading Label For Peel-off Mode option 3. Loading Label In Cutter Mode 3.

This amount is subject p,us change until you make payment. Update History Modify section 3.

Skip to content Others. Lower inner cover Lower cover 1.

Page 39 Label loaded completely in peel-off mode Reassemble parts in reverse procedures. The item may have some signs of cosmetic wear, but is fully operational and functions as intended.

Plastic pillar Copper pillar Squeeze two sides of platen assembly and take it out. Fasten the RJ45 connector daughter tsc tdp plus upon the plastic and copper pillar. Be the first to tsf a review.

TSC TDP-245 Plus

The ground wire from the tvp-245 must be screwed on the daughter board at copper pillar. Insert the screw of hinge holder Insert the here screw of hinge holder here Remove 6 screws tsc tdp plus the lower inner cover.

Related Drivers  I8KFANGUI DIGITALLY SIGNED DRIVER DOWNLOAD

Read more about the condition.

Mar 30, The driver was extensively tested with different NiceLabel ydp versions. Arrange the cutter module cable through the bezel.

Replace the PCB or replace a new lower cover. Head close receiver 3.

Upside down the printer. Tec you touch it careless, please use ethanol to clean it. Mar 30, Hold the lower cover and lift up the top cover open levers to separate the lower inner cover and the lower cover.